Fasteners
100% virgin twisted poly, twice as strong as manila, resistant to rot, mildew, marine growth and petroleum products.
Factory number indicated thickness (inches).
Finish nails are used for trim and fine finishing work where a smaller, less visible head is desired. PRO-FIT(R) finish nails come in three basic styles finish, casing and hardened trim. They are used to set door and window frames, apply trim and in other applications where appearance is important.
GRK's RSSa,,c screw is made of specially hardened steel to provide you with high tensile, torque and shear strength. The sharp threads and points bite instantly into the material (including hardwood), reducing the splitting effect due to smaller shanks. RSSa,,c screws that are 3-1/8 in and longer have CEE threads which enlarge the screw hole for the non-threaded portion of the fastener, allowing the wood to settle easily and increases the screw's drawing strength. The CEE thread also reduces the friction on the screw shank which can result in lowering the driving torque and the likelihood of splitting the wood. This is why the RSSa,,c screw is an efficient lag screw alternative. Our round head with built-in shield (washer type head) has no sharp edges like conventional lag screws. The added shoulder (nominal diameter) underneath the washer has the ability to center the RSSa,,c screw in pre-drilled hardware like hinges and connector plates.
For fastening applications in concrete, hollow block, grout filled block and brick. Contractor-grade anchors. Anchor diameter equals hole diameter. Applications: Machinery and supports, window frames, partitions, cabinets and shelves, duct straps, pipe support.
Do Not use on coated cable, if used on coated cable, remove coating from assembly area.
GRK's RSSa,,c rugged structural screw is made of specially hardened steel to provide you with high tensile, torque and shear strength. The sharp threads and points bite instantly into the material (including hardwood), reducing the splitting effect due to smaller shanks. RSSa,,c screws which are 3-1/8 in and longer have a six threaded CEE thread that enlarges the screw hole for the non-threaded portion of the fastener, allowing the wood to settle easily and increasing the screw's drawing strength. The CEE thread also reduces the friction on the screw shank which can result in lowering the driving torque and the likelihood of splitting the wood. This is why the RSSa,,c screw is an efficient lag screw alternative. Our round head with built-in shield (washer type head) has no sharp edges like conventional lag screws. The added shoulder (nominal diameter) underneath the washer has the ability to center the RSSa,,c screw in pre-drilled hardware like hinges and connector plates.
Masonry nails are hardened nails designed to be driven into concrete or the mortar used to hold together bricks or cement blocks. This rigidity also lends masonry nails to a wide variety of installations ranging from attaching plywood subfloor to securing carpet tack strips.
Flexible round head conforms to surface making it difficult for water to get under the cap. Can be used for roofing felt, sheathing, polyethylene, roll roofing, re-roofing, chicken wire, wire lathe.
Class 2A thread fit. Hot rolled, cold drawn, low carbon steel. Can be cut, heated and bent. Meets ASTM A307 specs.
Do Not use on coated cable, if used on coated cable, remove coating from assembly area.
Class 2A thread fit. Hot rolled, cold drawn, low carbon steel. Can be cut, heated and bent. Meets ASTM A307 specs.
Class 2A thread fit. Hot rolled, cold drawn, low carbon steel. Can be cut, heated and bent. Meets ASTM A307 specs.
Class 2A thread fit. Hot rolled, cold drawn, low carbon steel. Can be cut, heated and bent. Meets ASTM A307 specs.
Class 2A thread fit. Hot rolled, cold drawn, low carbon steel. Can be cut, heated and bent. Meets ASTM A307 specs.
