Fasteners

National Hardware 3243BC Clevis Slip Hook, Working Load Limit: 5400 lb, Trade Size: 3/8 in, Steel, Blue, Suitable for: Equal or Lower Grade Chains

National Hardware 3166BC Spring Snap, Working Load Limit: 800 lb, Snap Opening Size: 9/16 in, Stainless Steel, Zinc, Dimensions: 3-1/4 in L

Maximum rope size 3/16 in. Designed for use with rope or cord in indoor and outdoor applications. Swivel eye eliminates tangling. Sheave rolls smoothly. Can be rigged as a block and tackle to reduce line pull. Zinc die-cast body with solid brass sheave.

Designed for making quick connections with chain in industrial and construction applications. Meets Grade 70 hook specifications. Removable clevis is for easier rigging. For use with Grade 70 transport chain or with chain of a lower grade. Manufactured from forged steel. Not designed for over-head lifting.

Designed for making quick connections with chain in industrial and construction applications. Meets Grade 70 hook specifications. Removable clevis is for easier rigging. For use with Grade 70 transport chain or with chain of a lower-grade. Manufactured from forged steel. Not designed for over-head lifting.

National Hardware 3112BC Interlocking Spring Snap, Working Load Limit: 738 lb, Snap Opening Size: 5/8 in, Wire Diameter: 7/16 in, Steel, Zinc, Dimensions: 4.72 in L

BARON Spring Hook, Working Load Limit: 700 lb, Snap Opening Size: 3/4 in, Stainless Steel, Dimensions: 5-1/2 in L

5/8-11 X 72 GALV THREAD ROD

3/4-10 X 72 GALV THREAD ROD

1/2-13 X 36 GALV THREAD ROD

5/8-11 X 36 GALV THREAD ROD

3/4-10 X 36 GALV THREAD ROD

Factory number indicated thickness (inches).

Warning, use shackles only as indicated. Shackles must be inspected for wear, distortion and damage before use. If the pin or bow is worn, distorted or damaged, discard the entire shackle and replace. Do not use round pin shackles in rigging applications. Screw pin shackles should not be used if there will be movement on the pin. Movement could cause the pin to unscrew and drop the load. Always stand clear of loads being lifted.

Connections for chain and attachments. When using cold shuts with chain, use one size larger than chain size. With a hammer, drive the open end through the cold shut eye then peen the extended end to prevent opening. Note: Cold shuts should not be reused after closure has been made. Do not use for overhead lifting.